Technique Print Samples - page 23

Appendix I
Autoread
The
Autoread
menu selects what will happen to paths’ statuses when timecode
stops. This can be set to
Autoread
, to prevent accidental erasure of the data you
have just written, all paths will be set to
Read
.
No Autoread
leaves all paths’ status unchanged.
Autodisarm
turns off
Touch
Write
for any faders in this mode.
Both
also does this, along with putting paths into
Read
.
Appendix J
On Stop modes
The
On Stop
menu contains settings which determines what happens to data for
later timecode values than where the tape is stopped.
In
Write To End
, the current positions are written to 23:59:59:24.
In
Write To Next
, current positions are written until previously written data is
encountered, at which point this becomes active.
In
Return To Mix
, the previously held pass data is used from the point at which
you stopped.
21
9098i Automation - Getting Started Guide
1...,13,14,15,16,17,18,19,20,21,22 24,25,26,27,28,29,30,31,32
Powered by FlippingBook